Pockets

Once my jacket is constructed I then add all the embellishments and pocket variations.

.  I ended up with just two pockets, with the trim at my waistline.  I liked the way it proportioned the jacket on me.

I used this Clover measuring guide to give me my rounded bottom edges.

Here is my thread traced pocket shape through the fashion fabric and silk organza on the back.

 View of the silk organza side.

I then placed my lining over the silk organza side of my pocket.

 Pinned my pocket center line.

 Using white chalk drew a center line.

 Walking foot on my machine and tension dialed up I machine stitched down the white marked center line of my pocket, leaving an inch at the top and the bottom of the pocket.

 You can see here that I am able to pull my threads through and tie them off with the inch allowance.

I then measured from the center parallel lines about an inch apart, leaving an inch allowance on the sides.

I continued to machine quilt my fashion fabric, silk organza, and lining together.

You have to tie off all of those threads between the silk organza and lining.

You just fold your fashion fabric to the desired pocket shape and pin down your lining.  I start with the top edge.

 Then work on the bottom edge, lightly pressing down the lining first.

 Carefully shape the corners.

 My layout of my trims and embellishments used.

Added my fringe first by basting it down in the matching garment thread.

Then added my cream trim, hand stitching down.

I next added my blue trim, centered over the cream trim.  This shows the back side and how it sits inside the pocket.  I then slip stitched my lining around the pocket shape.  I also at this stage added covered snaps to my pocket.

Carefully placed the pockets onto my jacket and hand stitched them on.  I did add the buttons for an added embellishment.